Directed Electronics 1500X User's Guide download pdf (Page 19)

AngioDynamics, Inc. Model 1500X User’s Guide and Service Manual

160-103990 Rev 03 Page 17

8.3 Maintenance

The RF Generator is designed for indoor use in a dry operating room/procedure room

environment. The RF Generator requires no maintenance or calibration by the user. The user

should not remove the cover. Removal of unit cover voids the warranty. All maintenance and

calibration must be referred to Customer Service at AngioDynamics, Inc. Refer to Section 1 for

applicable phone numbers.

8.4 Cleaning and Disinfecting the RF Generator

The RF Generator should be given reasonable care and be kept clean and sanitary. The RF

Generator may be cleaned with a damp disposable wipe moistened with 70/30 isopropyl alcohol

and water.

WARNING: Electric shock hazard. Do not saturate the RF Generator with liquids. Do not allow

liquids to run inside the unit. Do not immerse the RF Generator in water. Shut off the RF

Generator, and disconnect power before cleaning. Do not sterilize the RF Generator.

CAUTION: Do not use abrasives, caustics, or mineral spirits. Use of these agents to clean the

RF Generator, or any of its accessories may cause damage and voids the warranty. All

electrical connections must be air-dried before use.

8.5 Fuse Replacement

Turn the Generator off with the switch in

the back and unplug the power cord.

Get a small flat blade screwdriver and

pry open the fuse access panel on the

Line Input module.

2) Below is Line Input module with fuse

access panel open. Note, there are two

fuse modules. They are marked with

arrows. Pull on each of the arrows to

slide the fuse module out.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 29 30

No comments

Directed Electronics 1500X User's Guide Page 19