Directed Electronics 1500X User's Guide Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 30
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
AngioDynamics, Inc. Model 1500X User’s Guide and Service Manual
160-103990 Rev 03 Page 16
8. CARE AND MAINTENANCE
8.1 Software Installation
If you receive a software module separate from the RF Generator (for example,
software with upgrades), follow these instructions for installation. You will need a
Phillips screwdriver.
8.2 Software Updates
8.2.1 Removal of Existing Software Module
Every RF Generator is shipped with a software module already installed. In order to
install a different software module, the existing software module must be removed. To
remove the software module,
Turn off power to the RF Generator using the power switch on the back of the RF
Generator
Locate on the back of the RF Generator a black cover labeled, “Software Module
Access”. Remove this cover by removing the two screws (at the top and bottom
of the cover) with a Phillips screwdriver. Pull the black cover off.
Underneath the cover are the installed software module and a button. Push the
button to eject the software module. Remove the software module.
8.2.2 Installation of Software Module
To install a different software module (see diagrams below),
Orient the software module so that the arrow on the software module is facing
the insertion slot and the wording on the software module label is right side up.
Insert the software module into the slot. The button will pop up.
Orient the Software Module Access cover so that the arrow on the cover is
pointing up. Place the cover over the button and installed software module.
Replace the two screws with a Phillips screwdriver.
Turn on the RF Generator and verify that the software module was properly
installed (there is information displayed on the LCD).
Installation of Software Module and Software Module Access Cover
Software Module
Software Module
Access Cover
Software Module
Slot (on back of
RF Generator)
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Comments to this Manuals

No comments