Directed Electronics Nissan Installation Guide download pdf (Page 6)

is detected within 5 seconds of transmission, the sensors and the multiplex trigger input on the BLUE wire will

be shunted until 5 seconds after the ground is removed. This allows the customer to access the trunk, remote

start the vehicle, or roll the windows down without first disarming the alarm. (See

Bypassing Sensor Inputs

section of this guide.)

This wire is used in vehicles that have a positive (+) switched dome light circuit. Connect the violet wire

to a wire that shows (+)12V when any door is opened, and ground when the door is closed. This wire will report

Zone 3.

Remove any paint and connect this wire to bare metal, preferably with a factory bolt rather than your own screw.

(Screws tend to either strip or loosen with time.) We recommend grounding all your components, including the

siren, to the same point in the vehicle. See the following diagram.

Connect this wire to an ignition source. This input must show (+)12V with the key in run position and during

cranking. Make sure that this wire cannot be shorted to the chassis at any point. This wire will report Zone 5.

HH11//88 BBLLAACCKK ((--)) cchhaassssiiss ggrroouunndd ccoonnnneeccttiioonn

HH11//77 VVIIOOLLEETT ((++)) ddoooorr ttrriiggggeerr iinnppuutt,, zzoonnee 33

1 2 3 4 5 6 7 8 9 10 11 ... 28 29

No comments

Directed Electronics Nissan Installation Guide Page 6