Directed Electronics Nissan Installation Guide download pdf (Page 22)

2222

ooppeerraattiinngg sseettttiinnggss rreemmoottee ccoonnttrrooll ccooddee lleeaarrnniinngg

Many of the operating settings of this unit are programmable. They can be changed whenever necessary through

Operating Settings Remote Control Code Learning. The Valet®/Program push-button switch, plugged into the blue

port, is used together with a programmed transmitter to change the settings.

The operating settings dictate how the unit operates. It is possible to access and change any of the feature set-

tings using the Valet®/Program switch.

TToo eenntteerr OOppeerraattiinngg SSeettttiinnggss CCooddee LLeeaarrnniinngg::

OOppeenn aa ddoooorr.. ((

The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.)

IIggnniittiioonn..

Turn the ignition on, then back off. (The H1/9 YELLOW switched ignition input

must be connected.)

CChhoooossee..

Within 10 seconds, press and release the Valet

/Program switch the number of

times corresponding to the feature number you want to program (see the

Features Menu

section of this guide). The LED ON settings listed in the

Features Menu

table are the factory

default settings.

Once the Valet/Program switch has been pressed and released the number of times corre-

sponding to the feature you wish to program, press it once more and

HHOOLLDD

it. After a

second, the LED will flash to indicate which feature you have accessed. For example, groups

of five flashes would indicate access to Feature 5. The siren will also chirp five times.

TTrraannssmmiitt..

While

HHOOLLDDIINNGG

the Valet®/Program switch, you can select the desired feature

settings using the remote transmitter. As shipped, the unit is configured to the default LED

ON settings. Pressing Button I while

HHOOLLDDIINNGG

down the Valet/Program switch will program

the feature to the LED ON settings. The siren will chirp once to indicate the one-chirp

setting has been selected. Pressing Button II while

HHOOLLDDIINNGG

down the Valet/Program

switch will change the setting to the LED OFF setting. The siren will chirp twice indicating

that the LED OFF setting has been selected.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29

No comments

Directed Electronics Nissan Installation Guide Page 22