Directed Electronics 3100 Instruction Manual download pdf (Page 9)

Emergency Override

The following procedure disarms the system when a programmed re-

mote is not available.

1. Turn the ignition On.

2. Press and release the Valet button once.

3. The siren output ceases and the system is disarmed.

Note

As a precaution, if programmed for Passive Arming the sys-

tem should be placed into Valet Mode until a remote is

available.

Trigger Zone Fault Report

When armed by remote command the system runs a status check of

the alarm trigger zones (see Table of Zones on next page). Open

zones (usually caused by dome light delay or open trunk) are by-

passed and reported via the status LED, while all other trigger zones

remain active and are monitored to protect the vehicle. Should an

open zone self correct (such as dome light turns off), it becomes active

and is then monitored normally.

The siren chirps once again a few seconds following the arming chirps

as an audible alert, and the status LED ﬂashes in groups to indicate

the zone number.

Alarm Report

If the alarm was triggered while armed, it will be reported when the

alarm is disarmed via siren chirps, parking light and status LED ﬂashes.

The siren chirps 4 times (or 5 times if NPC On, See Nuisance Preven-

tion (NPC) on next page), the parking lights ﬂash 3 times, and the

status LED ﬂashes in groups to indicate the last two zones that were

triggered (see Table of Zones on next page). The report output will

repeat for each disarm operation until the ignition is turned on.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Directed Electronics 3100 Instruction Manual Page 9