User guide
CANMAX400 Standalone
Revision: 16-Nov-09
To configure the remote control features press and release the command button. The LED next to the button will turn ON
then OFF. The remote beeps to indicate the feature configuration.
Button Command
Confirmation
Auto-button lock
• When Arm LED is OFF, buttons will not lock.
• LED ON: The buttons automatically lock 60 seconds after the last button operatio
avoid accidental Command operations. When locked, if any command button is
n to
pressed the remote will emit an error output.
en . If button lock is ON, press , and th
Remote beeps
• Disarm LED OFF: The remote will not emit beeps except wh
rm LED ON: The remote will emit beeps normally.
en programming.
LED blinking: The remote will emit beeps only for alarm trigger messages from
system.
• Disa
• Disarm
the alarm
Runtime low
alert feature
This feature is not available on the 1-way remote.
• Remote Start LED OFF: The remote will ignore Runtime Low Alert messages.
• Remote Start LED ON: The remote will emit feedback output for Runtime Low Alert
messages.
These messages will be automatically sent while Remote Start is
ON to alert you when the
runtime remaining is at 3 minutes, and again at 1 minute before shut down.
Page
mode/Power
saver
This feature is not available on the 1-way remote.
• Aux LED OFF: The remote will not wake up and listen for messages from the system
to extend battery life. Note: This means the remote will not receive alarm trigger page
• Aux LED ON: the remote will wa
s.
ke up to listen for messages from the system.
is
• Aux LED blinking: Power saver mode (see note below).
Power saver automatically turns off the remote pager if a button on the remote has not
been pressed for more than 72 hours and will be restored after any button on the remote
pressed.
Warning – Safety first!
The following safety warnings must be
Due to the complexity of this system, in
observed at all times:
stallation of this product must only be performed by an authorized Directed dealer.
rt the vehicle via a command signal from the remote control transmitter.
closed area or partially enclosed area without ventilation (such as a garage).
he remote start system must
keep out of reach
start the vehicle.
ING FROM ADJACENT LIVING AREAS TO THE ENCLOSED OR PARTIALLY
ENCLOSED VEHICLE STORAGE AREA MUST AT ALL TIMES REMAIN CLOSED. These precautions are the sole
ave your car in neutral. You must read this Owner’s Guide to familiarize yourself with the proper procedures
regarding manual transmission remote starters. If you have any questions, ask your installer or contact Directed at 1-800-
When properly installed, this system can sta
Therefore, never operate the system in an en
When parking in an enclosed or partially enclosed area or when having the vehicle serviced, t
be disabled using the installed toggle switch. It is the user’s sole responsibility to properly handle and
from children all remote control transmitters to assure that the system does not unintentionally remote
THE USER MUST INSTALL A CARBON MONOXIDE DETECTOR IN OR ABOUT THE LIVING AREA ADJACENT TO
THE VEHICLE. ALL DOORS LEAD
responsibility of the user.
Remote starters on manual transmission vehicles operate differently than those with automatic transmission because you
must le
753-0600.
© 2009 Directed Electronics, Inc. All rights reserved.
8
(30 pages)
(50 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals