Directed Electronics Smart start Installation Guide download pdf (Page 2)

3. Install the

VSM200/250

or

DSM200/250

using

the information in the

wiring

diagram

and

steps

(Note CAUTIONS during installation).

a. Configuration Wires: Connect the loose

gray

or

white configuration wire(s) to match the

desired application

(see

table below).

MODE

ESP2

Open Open

D2D,

RSR/RXT

GND

Open

Autostort/

AstroStort

Open

GND

b. Connect the serial data cable

and

adapter to

the correct

port

of

the main module. For D2D

RSR/RXT

applications, connect the serial

data

cable

and

adapter

to Xpresskit module.

c. Complete the main

power

connections.

d.

When

power

is

connected, the module

be-

gins an initialization procedure that may

take several minutes. During this procedure,

progress

is

reported

via

the flashing

Amber/

Green

LEDs

next to the module cable.

When

both

LEDs

turn on solid, the initialization pro-

cedure

is

completed

(See

Status

LEOs

for a

description

of

the various

LED

states).

4.

Verifv

and

Activate the SmartStart module:

The

following steps need to be performed for the

Verification/

Activation

of

the Directed SmartStart

module.

a. Collect Customer Information:

2

b.

Log

on to: www.directechs.com, and click on

the

SmartStart link.

c.

Follow the on-screen directions to activate

and test a SmartStart device. If this

is

the

cus-

tomer's first SmartStart system, you

will

be

prompted to enter their information as col-

lected

in

step

4a.

d.

Set

configuration for commands to match the

installed application.

e.

Test

the SmartStart system from the website

using the supplied function links.

f.

The

customer is sent log-in information via

e-mail. After

logging

into the site

at

www.

mysmartstart.com, they must select and

pay

for the service plan in

order

to start using the

system.

Status

LEDs

Amber

LED

states:

•

Off:

No

cellular communication. Check

connections

such

as module harness.

• Flashing slowly:

The

module

is

seeking

cellular system communication.

If no cell coverage

is

available

the

Amber

LED

continues

to

flash slowly, move the

vehicle to a location with better reception.

• Flashing quickly:

The

module

is

negotiat-

ing with a cellular system.

•

On

solid: Communication successfully

es-

tablished.

Green

LED

states:

•

Off:

Communication not established with

the remote start main unit

or

no serial de-

vice

is

connected.

Check connection

at

the Bitwriter port,

once connected properly the

LED

turns on

after resetting the

power

to the SmartStart

module.

•

On

solid: Communication successfully

es-

tablished with the remote start main unit.

Please return this

guide

and point the customer to

steps

4a

and

4f

after successfully completing the in-

stallation

as

it contains details required for account

setup.

Notes: SmartStart response time can

vary

depend-

ing on cellular

coverage and network congestion.

Operating

temperature range:

-30

°C to +

70°(.

Additional information

can

be

found at:

www.di rectechs.com

E

LECTRONICS

©

20

11

Direct

ed

Electroni

cs

. All rights

rese

rved .

1 2 3 4 5 6

Comments to this Manuals

No comments